One of the most important parts of any RV is the water tank. It’s where we store potable drinking and bathing water and it can be a vital resource in an emergency. To ensure that your water tank is ready to go at all times, you’ll need to clean it regularly.
What Is The RV Water Tank?
The RV water tank is the section of the RV that stores all of your drinking and cleaning water. The tank is made out of rubber or metal, which provides a protective covering for the toxic chemicals that are inside.
Why You Should Clean Your RV Water Tank Regularly?
Regularly cleaning your RV water tank is an important requirement to ensure that you’re drinking and using safe drinking water. If you don’t, there’s a chance that the water could have harmful chemicals and contaminants.
The Steps Involved In Cleaning an RV Water Tank
In the event that you find that your tank needs a deep cleaning, please follow these steps below for the best results.
1) Rinse off any visible sediment on the bottom of the tank with water before scrubbing. The easiest way to do this is by filling the tank up about 1/4 to 1/2 full with water and letting it run for about 5 minutes or so before turning off your water pump. This will help loosen up any dirt, grime, etc. without using bleach or other harsh chemicals.
2) Inspect all of your hoses and pipes to be sure that they are securely fastened in place and free of leaks. If you find that there are any leaks present, then tighten them immediately to avoid exposing yourself to harmful chemicals, visit this link.
3) Use a long handled brush, hose and water pressure to remove any dirt or sediment in the tank. Start from the top of the tank and work your way down. Make sure that every part of the inside is scrubbed with a brush or other implement, and once you’ve scrubbed it all, flush the entire tank with clean water to remove the dirt and grime.
4) Fill up your tank completely, then turn on the water pump. Let it run for a few seconds to loosen up anything that’s stuck at the bottom or sides of the tank, then turn off the water pump. Repeat this process a few times to make sure that you got all of the sediment and grime out of the tank. Allow it to sit for about 5 minutes, then repeat the process again until it stays clean when you turn off the water pump.
5) Let the water run for 5 minutes, then turn off the pump. Flush out all of the taps so that they are clear and free of debris.
6) Fill up your tank completely and make sure that there are no leaks present.
7) Turn on all of the taps at the same time, and then turn off all of them right away. Repeat this process a few times to ensure that you are getting all of the air bubbles out.
8) Once you are certain that there are no leaks present, then your tank is completely cleaned and ready for use.
9) Turn on all of the taps and let the water run for a few minutes before using it to ensure that you get rid of all of the chemicals and debris.
10) If your tap is slow, you may need to replace the O-ring on it. Just remove the washers and the O-ring assembly from the tap, and then replace it with a new one.
Conclusion
You should clean your RV water tank regularly to protect yourself and your family from harmful chemicals that can be in the pipes. The process is pretty straightforward. We hope that after reading this post, you will be able to clean your RV water tank easily.